@[email protected] to [email protected]English • 1 month agoTwo Open Source Projects Combine to 3D Print a Working Replica Key Using a Flipper Zerowww.hackster.ioexternal-linkmessage-square37fedilinkarrow-up1160arrow-down15
arrow-up1155arrow-down1external-linkTwo Open Source Projects Combine to 3D Print a Working Replica Key Using a Flipper Zerowww.hackster.io@[email protected] to [email protected]English • 1 month agomessage-square37fedilink
minus-square@[email protected]linkfedilinkEnglish2•1 month agoI fully agree, but most locks aren’t in that state. 95% of the locks you might want to use this technique on would be in a reasonable condition.
minus-square@[email protected]linkfedilinkEnglish1•edit-21 month agoYes, I agree, it’s perfectly fine - jamming the door is more of a phobic anxiety. Then again, 95% of such locks are prob vulnerable to simpler attacks.
I fully agree, but most locks aren’t in that state. 95% of the locks you might want to use this technique on would be in a reasonable condition.
Yes, I agree, it’s perfectly fine - jamming the door is more of a phobic anxiety.
Then again, 95% of such locks are prob vulnerable to simpler attacks.